1、下天然氣好色先生在线观看的氣缸蓋，刮清氣缸套上部的炭灰和油汙。

1. Lower the cylinder head of the natural gas generator set and scrape off the carbon ash and oil stains on the upper part of the cylinder liner.

2、拆下機體下窗口蓋板，轉動曲軸，將要拆下的天然氣好色先生在线观看活塞轉到上止點稍後的位置。

2. Remove the cover plate of the lower window of the machine body, rotate the crankshaft, and turn the piston of the natural gas generator set to a position later than the top dead center.

3、拆下連杆螺釘時，注意用手托住連杆蓋，以防止墜入油底殼內，並防止碰傷軸瓦。

3. When removing the connecting rod screws, be careful to hold the connecting rod cap with your hands to prevent it from falling into the oil pan and damaging the bearing shells.

4、從連杆下端將活塞連杆往上推，自天然氣好色先生在线观看氣缸套上口沿氣缸中心線取出活塞連杆，取出時嚴防連杆碰傷氣缸套內壁。

4. Push the piston connecting rod upwards from the lower end of the connecting rod, and take out the piston connecting rod from the upper port of the cylinder sleeve of the natural gas generator set along the centerline of the cylinder. When taking out, be careful not to damage the inner wall of the cylinder sleeve by the connecting rod.

將活塞放在機油內加熱至100~120C，取出活塞銷。拆下活塞後，把天然氣好色先生在线观看連杆軸瓦、連杆蓋和連杆螺釘仍裝到相應的連杆體上，並進行清洗和檢查配合麵的磨耗情況或更換損壞的零件。希望以上的介紹能給用戶帶來幫助。

Heat the piston in engine oil to 100-120C and remove the piston pin. After removing the piston, install the connecting rod bearing shells, connecting rod caps, and connecting rod screws of the natural gas generator set onto the corresponding connecting rod body, and clean and inspect the wear of the matching surface or replace damaged parts. I hope the above introduction can be helpful to users.