在線谘詢
官方二維碼
當前位置：
2021.02.01
高停低起空氣增壓係統特點
高停低起空氣增壓係統是台州菲恩特在空氣增壓係統的基礎上，配備數顯智能壓力表，這款設備適合部分工廠氣源偶爾不夠的情況下使用，如；工廠設備需求壓力為0.7MPa，工廠氣源偶爾會掉到0.7MPa的情況下使用這款，設定上線壓力0.71MPa下線壓力0.69，這樣當氣源高於0.7時增壓泵不會工作，就相當於高壓管路，這時空氣增壓泵是沒有消耗的。當壓力低於0.69MPa時空氣增壓係統會及時把壓力增壓到0.71MPa。相對與空氣增壓係統這款設備有效的節能減排很多，同時增加增壓泵的使用壽命。
The high stop low start air pressurization system is based on the air pressurization system of Taizhou feinte, which is equipped with digital display intelligent pressure gauge. This equipment is suitable for use when the air source of some factories is occasionally insufficient. For example, when the demand pressure of the factory equipment is 0.7MPa and the air source of the factory occasionally drops to 0.7MPa, this equipment can be used with the setting of online pressure of 0.71mpa and offline pressure of 0.69 At 0.7, the booster pump will not work, which is equivalent to the high-pressure pipeline. At this time, the air booster pump is not consumed. When the pressure is lower than 0.69mpa, the air pressure boosting system will boost the pressure to 0.71mpa in time. Compared with the air supercharging system, this equipment has a lot of effective energy saving and emission reduction, and increases the service life of the booster pump.
高停低起空氣增壓係統參數：
Parameters of high stop low start air supercharging system:
1；增壓範圍：0-4MPa可設定。
1. Pressurization range: 0-4mpa, can be set.
2；流量範圍：360-1800L/min。
2. Flow range: 360-1800l / min.
3；上線壓力設定範圍：0-4MPa。
3. Setting range of online pressure: 0-4mpa.
4；下線壓力設定範圍：0-4MPa。
4. Setting range of downline pressure: 0-4mpa.
5；氣源進氣壓力：2-8bar。
5. Air inlet pressure: 2-8bar.
6；輸出壓力範圍：0-4MPa。
6. Output pressure range: 0-4mpa.
7；氣源要求:潔淨壓縮空氣。
7. Air source requirements: clean compressed air.
上一篇：高停低起空氣增壓係統特點
下一篇：4種沼氣發電方案